Sealife DC100 User Manual download pdf (Page 21)

D) Underwater, the Flash is always ON in all film models. The flash of digital cameras is

automatic in the SEA mode and always on in the EXTERNAL FLASH mode. An exter-

nal flash always enhances colors. Wait for FLASH READY light to turn on after each pic-

ture (about 8 to 10 seconds).

E) On land, outside the housing, the flash is automatic. The ReefMaster-RC film camera

allows you to manually override it by holding the switch in the ON or OFF position while

you are shooting. Digital models allow several flash modes.

F) Making prints: Film: Tell your processing lab that you have underwater pictures. Ask

your lab to increase red and yellow until colors are balanced. Have your lab make a few

proof prints with different settings. Digital: Use only the best photo glossy paper.

G) For best pictures use SeaLife Macro and Wide Angle lenses and external flashes.

SeaLife accessories can be used for digital as well as for film camera models.

2. Set up Housing

A) All models:

Inspect and clean O-ring before sealing camera in housing.

Close housing carefully. Make sure that the Moisture Muncher or any other debris

does not obstruct O-ring.

Do not apply any force to the housing, lid, buttons, or trigger in order to avoid flooding

the camera and housing.

Camera goes into power save mode after about 2 minutes. To reactivate, press shut-

ter lever lightly.

B) Digital models

Keep power off as much as possible. Turn power on only before taking pictures.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 63 64

No comments

Sealife DC100 User Manual Page 21