Sealife DC100 User Manual download pdf (Page 29)

Loading film - Film Cameras

a) Use 200 speed 24 exposure film and 2 fresh AA

Alkaline batteries. Replace batteries if “Flash

Ready” light takes more than 15 seconds to recy-

cle.

b) Turn camera power ON (below lens of inner

camera.)

c) Before loading film, push shutter button once to

test camera advance.

d) Insert film roll. Make sure roll is properly seated

onto rewind shaft..

e) Pull film tab over and into take-up spool and

press shutter until film engages. Film should lay

flat across film plane and sprocket teeth.

f) Close film door. If the film door is obstructed by

film roll, remove and re-insert roll until film door

closes without any obstruction.

g) Push Shutter button to advance film to picture

“1” in the frame counter window.

h) You might advance film by one frame with the

film door open to check proper advance and posi-

tion of the film.

Loading a Flash Card - Digital Cameras

Even though the camera has an 8 MB built-in

memory, you should use a high capacity flash card

with 32 or better 128 MB on your vacation.

Advance until frame counter

reads 1. Film counter turns red

4 frames before end of film.

Inserting a flash card must be

slowly and carefully.

Close door. If hatch does not

close easily, film cartridge is

not in correct position.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 63 64

No comments

Sealife DC100 User Manual Page 29