Sealife DC100 User Manual download pdf (Page 20)

IV. Quick Tips

1. Quick Setup of camera

A) All camera models:

Keep everything clean and dry. One drop of water inside the housing can cause the

front lens to fog underwater.

Use SeaLife Anti-Fog Desiccant and a drop of anti fog lotion inside on the housing

port. Load the camera in dry, cool air, best in an air conditioned room.

B) Film camera models:

Use 200 speed 24 exposure film and 2 fresh AA Alkaline Batteries. Replace batteries

if “Flash Ready” light takes more than 15 seconds to recycle.

• Turn camera power ON (below lens of inner camera.)

• Before loading film, push shutter button once to test camera advance.

• Insert film roll. Make sure roll is properly seated onto rewind shaft.

• Pull film tab over and into take-up spool and press shutter button until film

engages. Film should lay flat across film plane and sprocket teeth.

• Close film door. If the film door is obstructed by film roll, remove and re-insert roll

until film door closes without any obstruction.

With camera power on, insert loaded camera into housing. Keep camera and inside

of housing dry.

C) Digital Cameras:

Insert freshly and fully charged SeaLife NiMH batteries.

Lithium AA batteries may also be used. They’re expensive but last twice as long.

Set camera to Sea Mode, External Flash Mode or Land Mode.

Camera power shuts off automatically after about 2 minutes.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 63 64

No comments

Sealife DC100 User Manual Page 20