Sealife DC1000 Specifications download pdf (Page 63)

Underwater Housing Instructions >>

Maintaining a waterproof seal

Every SeaLife housing is tested for quality and a waterproof seal. It is your

responsibility to properly care for the O-ring and O-ring contact surfaces

to maintain a waterproof seal. Carefully follow these important O-ring care

instructions. Not following these care instructions may cause the waterproof

housing to leak and void your warranty.

1. Carefully inspect O-ring and O-ring contact surfaces for damage (cuts,

scratches, tears, cracks, dents and any other imperfections.) before every

use. Rub ﬁnger along O-ring and O-ring contact surfaces to inspect for

damage. Replace O-ring or have waterproof housing serviced if the O-ring

or O-ring contact surfaces are damaged. Do not use underwater housing

if O-ring or O-ring contact surfaces are damaged. Replacement O-rings

are available at your local authorized SeaLife dealer.

Inspect and replace O-ring if damaged: A=Cut, B=Tear, C=Dent

2. Carefully inspect and clean O-ring and O-ring contact surfaces for sand,

hair and other debris before every use. Clean o-ring and o-ring contact

surfaces with cleaning brush provided.

Inspect and clean O-ring and O-ring contact surface for hair (#1) and

Sand or debris (#2)

Clean O-ring and O-ring contact surfaces with brush provided.

3. Make sure O-ring is completely seated into O-ring groove before sealing

housing. O-ring must not be twisted when seated in the o-ring groove.

See page 63 on instructions on how to install and remove O-ring.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 81 82

No comments

Sealife DC1000 Specifications Page 63